FEIN Power Tools GRIT GX 75 Contact grinding Figure, Face grinding Figure, Suction device Figure

GX75.book Seite 13 Freitag, 18. April 2008 11:14 11

GX 75		us
9.6 Contact grinding (Figure 10).		Fig. 10
	The workpiece must always lie
WARNING
	securely on the grinding rest and
the stop. Workpieces that are too small or too thin
may not be worked. Danger of injury from work-
pieces pulled into the machine.
➤ Check if the star-knob bolt is firmly tight-
ened.
➤ Ensure that the top protective cover is
secured with star-knob bolt and that the
side cover is shut.
➤ Check the gap size of the grinding rest.
➤ Check the position of the face-grinding rest.
The adjustment screws must be in the bot-
tom position.
➤ Check if the screws of spark guard are prop-
erly tightened.		WARNING
➤ Switch the machine on and check the belt
run.
➤ Place the workpiece firmly onto the grinding
rest.
➤ Guide the workpiece with both hands or
fasten it in a fixture.

9.7 Face grinding (Figure 11).

WARNING Hold the workpiece with both hands. The workpiece must

always lie securely on the face grinding rest and the stop. Workpieces that are too small or too thin may not be worked. Danger of injury from work- pieces being pulled in or thrown from the machine.

➤Loosen the star-knob bolts and remove the top protective cover.

➤Make sure that the gap size is correctly adjusted. (Figure 7)

Fig. 11

WARNING

➤Switch the machine on and check the belt run.

➤Guide the workpiece with both hands and remove it to upward after the working pro- cedure. (Figure 11)

9.8 Suction device (Figure 2)

➤The machine can be connected via the sleeve to a dust extraction system.

13