Checklist for Inoperative Machines
A
B
C
D
E
F
8
All Machines
If no indicator lights are lit:
•Make sure the plug is securely inserted in the receptacle on the back of the machine and into the wall outlet.
•Make sure the shredder is on (switch in “I” position).
If both the red and green lights are on:
Waste Box Full:
•Press rocker switch to “O” to stop the cutting system.
•Remove wastebox from inside cabinet and empty.
•Return wastebox, close door and
resume operation.
Door Ajar:
•Make sure door is completely closed.
•If the door is opened while the motor
is running, after closing the door, set the rocker switch to the “O” position and then to the “I” position to resume operation.
220, 220CC, 280, 280CC If only the green light is on:Paper Jam:
• Press rocker switch to “O” to stop the cutting system.
•Press and hold down rocker switch in “R” to reverse the cutting
system and back out jammed material (paper is pushed out)
•If the jam persists, slowly move the power switch back and forth
between forward (I) and reverse (R), always stopping for a moment in the off position (O). Do not switch the shredder rapidly between forward and reverse to force material through the shredder. Rapid rocking develops tremendous forces that can damage your shredder.
•Continue shredding in smaller quantities so as not to jam the machine further.
Overheated:
•If the motor is overheated, switch the machine off and allow motor to cool down for approximately 15- 20 minutes.
320,320CC, 380, 380CC If no lights are on:•Make sure the circuit breaker is not open. (press to reset).
If only the red light is on:
Paper Jam:
• Press rocker switch to “O” to stop the cutting system.
•Press and hold down rocker switch in “R” to reverse the cutting system and back out jammed
material (paper is pushed out). Rocker switch must be held in reverse for a few seconds to cause the red light to turn off.
•If the jam persists, slowly move the power switch back and forth
between forward (I) and reverse (R), always stopping for a moment in the off position (O). Do not switch the shredder rapidly between forward and reverse to force material through the shredder. Rapid rocking develops tremendous forces that can damage your shredder.
• Continue shredding in smaller quantities so as not to jam the machine further.
Overheated:
•If the motor is overheated, switch the machine off and allow motor to cool down for approximately 15- 20 minutes.
