Fellowes SB-85C, SB-80 manual Set-Up, Operation, Control Panel, To shred

English

Set-Up

•Open the cabinet door and pull the waste basket (2) completely out of the cabinet.

•Put plastic waste bag in basket (sample bags provided). Allow bag edges to overhang. Contact Fellowes to order more bags (part # 36052).

•Slide the waste basket into the cabinet and shut the cabinet door (6).

•Plug the power cord into a convenient outlet.

•Store this use and care manual in slot inside cabinet door (6).

Operation

For convenience, your shredder is equipped with an automatic-start sensor (8). This means that when the control switch (5) is in the automatic [I] position, the shredder will start running when paper is fed into it. The shredder stops a few seconds after the paper has passed through. Because the sensor cannot tell the difference between paper and other objects, this feature can be a hazard, especially to children and pets. To avoid accidents, turn off the shredder as soon as you are finished. Unplug shredder if it will not be used for an extended period.

Control Panel (13)

IAUTOMATIC Turns on the auto- matic-start sensor and the green Ready light.

OOFF

Turns off the auto- matic-start sensor and the green Ready light.

RREVERSE

Runs shredder in reverse mode. Press and hold to activate.

Safety Lock Light (7) If the shredder safety lock is on, the light is yellow.

13

Troubleshooting Lights

4

7

9 10 11

12

Ready Light (4) (Green)

Shredder is in automatic start mode.

Paper Jam (9) Shredder is jammed (e.g., too much paper fed at one time).

Door Ajar (10)

Cabinet is open

Overheat light (11) Shredder requires cool down period.

Basket Full (12) Waste basket is full or paper has collected under cutting cylinders.

To shred

•Plug in shredder with control switch (5) in off [O] position

•Press control switch to automatic [I] position; cutting cylinders will run for 1-2 seconds to signal readiness and green light (4) will turn on.

PAPER

•Insert the paper you wish to shred inside the sheet capacity measuring gauge (14) to avoid exceeding maximum sheet capacity. The paper that doesn’t

reach the bottom of the gauge should be set aside for the next shredding pass. (optional)

•Feed paper straight into entry (1), until the shredder automatically begins shredding; see Product Profile for limits on paper width, shreddable items, sheet capacity, etc.

•Shred for no more than 20 minutes; shredding longer will cause shredder to turn itself off for 30 minutes to cool down.

4