Fellowes SB-80, SB-85C manual Maintenance, Troubleshooting, CDs and DVDs

Models: SB-85C SB-80

1 64
Download 64 pages 6.04 Kb
Page 6
Image 6

English

Press control switch to off [O] position after cutting has stopped. With confetti-cut shredder, cutting continues for several seconds after paper has gone through in order to clear shred- ded paper from cutting cylinders.

CDs and DVDs

Hold CD or DVD at the edge and feed one at a time, straight into CD entry (10), releasing when shredding begins. Shredder will stop when CD has passed through entry. CDs will be shredded into small particles.

CAUTION: Do not hold CD or DVD with finger through the center ring while feeding into shredder.

In case of a paper jam, which may occur if the sheet capacity is exceeded or if paper is not put in straight, turn off and empty the basket if full. Then:

1)Press and hold control switch in reverse [R] position and attempt to back paper out of shredder.

2)If shredder jams in reverse mode, press control switch to automatic [I] position and attempt to continue shredding operation.

3)If shredder jams again, alternate control switch slowly between reverse [R] and automatic [I] positions to attempt to move jammed paper completely through shredder.

If you are unable to clear the jam using this method, turn off and unplug the shredder; remove wastebasket from the cabinet and carefully remove any paper extending below the cutting cylinders; insert wastebasket and repeat jam clearing procedure.

Maintenance

Regular emptying of the basket is important to ensure the smooth operation of the cutting cylinders. The shredder will not operate when the basket is full.

Regular oiling of the confetti-cut model (SB-85C) is also necessary to ensure proper performance. If you are running the shredder at or near capacity, we recommend oiling it monthly. Using Fellowes Powershred Lubricant #35250 or other non-aerosolvegetable-based oil in a long-nozzle container:

Apply oil over full width of paper entry (1) with shredder in off [O] position.

Press control switch to automatic [I] position which will cause shredder to run for about 2 seconds.

Press and hold control switch in reverse [R] position for 3–5 seconds.

Repeat above automatic [I] and reverse [R] sequence three times.

REMINDER: Do not use flammable synthetic oil, petroleum-based products or aerosol lubricants of any kind in or near the shredder at any time.

Troubleshooting

If you have a problem with your shredder, check the symptoms and remedies below. If you cannot solve the problem this way, contact Fellowes Customer Service. Do not open shred- der head to attempt repair: It could expose you to serious electric shock and will void your warranty.

5

Page 6
Image 6
Fellowes SB-80, SB-85C manual Maintenance, Troubleshooting, CDs and DVDs