Using the Optional Trim Stop
The optional Trim Stop is used to securely hold small work-
pieces for cutting mortises.
Installing the Trim Stop
1.With the fence tilted to 90 degrees, slide the Trim Stop over the fence face of the Domino joiner as shown. Make sure the Trim Stop is fully seated onto the joiner’s fence.
2.Slide the two latch tabs inward.
3.Tighten the two thumbscrews.
Setting the Stop Width
1.Loosen the two green thumbscrews on the bottom of the
Trim Stop.
2.Place the workpiece between the two guides and slide the guides inward.
3.Use the position gauge on the Domino joiner fence face to center the workpiece.
4.With the side guides tight to the workpiece and the workpiece centered in the position gauge, tighten the two thumbscrews.
Hint: Make note of where the workpiece lines up on the sight gauge, and use the sight gauge when cutting the mortise on the mating frame for a T‑joint frame.
Locked 
Position
Sight
Gauge
Thumbscrew
Latch
Thumbscrews
Workpiece
Using the Optional Hand Rail Fence
The optional hand rail fence is used to help stabilize rounded workpieces that won’t otherwise rest flat against the fence.
Installing the Hand Rail Fence
1.With the fence tilted to 90 degrees, slide the hand rail fence over the fence face of the Domino joiner as shown. Make sure the hand rail fence is fully seated onto the joiner’s fence.
2.Slide the two latch tabs inward.
3.Tighten the two thumbscrews.
If the hand rail fence is not sitting perfectly centered on the mortising location, it can be shifted to the side by adjusting the four gib screws.
Round
Stock
Locked 
Position
Thumbscrew
Latch
Gib Screws (4)
Supplemental Owner’s Manual | 13 |
