SlotServer | Page 9 of 14 |
|
|
Appendix A. Useful Features
Refer to the Configuration Manual for useful configuration features.
The unit may be removed under power for convenient swapping of modules.
Appendix A.1. LED Functions
Service Pin |
|
Run | LonSvc |
Node Off | Conf Err |
Sys Err | Com Err |
Rx Tx
The LonWorks Service pin can be used for commissioning the SlotServer into a LonWorks network.
LonWorks Activity can be determined using this LED as follows:
LON LED Activity
Explicit |
| Implicit – Not | Implicit – |
|
| Commissioned | Commissioned |
Off |
| Flashing | Off |
Figure 3: Diagram of SlotServer showing ports and displays
| LED |
|
| Description |
|
|
|
|
| When the SlotServer is powered up, this light will start flashing after |
|
Run |
|
| approximately 2 minutes. If this light does not flash, it is an indication that the |
| |
|
|
|
| firmware is not running, and that the SlotServer will not be operating. |
|
LonSvc |
|
| This LED indicates LonWorks activity. Refer to Figure 3. |
| |
|
|
|
| This light indicates that a device bound to the SlotServer on the LonWorks network |
|
NodeOff |
|
| is not communicating. Use the LonWorks Network Manager to troubleshoot the |
| |
|
|
|
| problem. |
|
|
|
|
| This light indicates an error in the configuration of the card. Since this model is |
|
Conf Err |
|
| shipped |
| |
|
|
|
| configuration is tampered with |
|
|
|
|
| This light indicates that an unexpected operation state occurred. The light can be |
|
Sys Err |
|
| reset by cycling power to the card. If the error |
| |
|
| FieldServer Technical support for assistance with troubleshooting after setting up |
| ||
|
|
|
|
| |
|
|
|
| the trade port as shown in Appendix A. |
|
|
|
|
| This light indicates that a communication error occurred. Use the LonWorks |
|
Com Err |
|
| Network Manager to troubleshoot the problem, or refer to the SlotServer |
| |
|
|
|
| configuration Manual. |
|
|
|
|
| These lights are related to the |
|
|
|
|
| Rx (Receive) light will flash red if the FieldServer is receiving data. The Tx |
|
|
| (Transmit) light will flash red if the FieldServer is sending data. (Note that due to |
| ||
(R1) |
|
| the nature of |
| |
|
|
|
| too). The frequency of the flashing is directly related to the frequency of data |
|
|
|
|
| transfer. |
|
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
