Changing The Filters
A. |
| A. |
| B. |
|
|
|
|
|
B.
E N G L I S H
A. Changing The Filter Cones
For best performance, replace Cones as recommended by manufacturer:
▼
▼MEDIpure®- every 6 months
▼Flat Disc Filter - every 6 months
CAUTION - DO NOT operate your power unit without Genuine FILTERQUEEN® Filter Cones in place. BEWARE OF IMITATIONS: Use only Genuine FILTERQUEEN® Filter Cones. Imitations can result in poor performance and cause damage to your unit.
1.Unplug power cord from wall and detach hose from power unit.
2.Release side clamps and remove power unit from dirt container.
3.Remove MEDIpure® Cone and set aside or discard when installing a new
4.Empty contents of dirt container into a large, open garbage bag. Allow contents of container to fall including used
washed and thoroughly dried to remove all dust and/or any odors.
5.Open a new
in the bottom of the dirt container. Be sure all edges of the Cone are even with the gasket of the dirt container.
6.Place the MEDIPure® Cone inside the
7.Replace power unit and lock side clamps in place. Be sure all three tabs of the
B. Changing The Flat Disc Filter
1.Unplug power cord from wall and detach hose power unit.
2.Release side clamps and remove power unit from dirt container.
3.Remove the Cone guard. Next, remove the Flat Disc Filter by pulling back the plastic retainer ring with your finger and lifting it out.
4.Replace Flat Disc Filter. Place the filter over the center section of the screen. Replace the retainer ring by squeezing ring. Make sure ring fits snugly under the three tabs of the plastic screen. Replace the Cone guard. Be sure the outer edge of the Cone is seated on the rubber lip around the circumference of the power unit and replace screw.
12