Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.
Symptom
No sound is heard.
Unable to record on an MD.
Poor radio reception.
Unable to operate the remote control.
Possible Cause
Connections are incorrect, or loose.
•You are using a prerecorded MD.
•The MD is
•The antenna is not connected correctly.
•The AM loop antenna is too close to the unit.
•The FM antenna is not properly extended and positioned.
•The path between the remote control and the remote sensor on the unit is blocked.
Action
Check all connections and make corrections. (See pages 6 – 9.)
•Change it with a recordable MD.
•Unprotect the MD. (See page 32.)
•Reconnect the antenna securely.
•Change the position and direction of the AM loop antenna.
•Extend FM antenna to the best reception position.
•Remove the obstruction.
Loaded CDs and MD cannot be ejected.
• The batteries have lost their charge. |
| • Replace the batteries. (See page 9.) |
• You are using the remote control |
| • Signals cannot reach the remote |
far from the main unit. |
| sensor. Move close to the main unit. |
|
|
|
• The main AC power cord is not |
| • Plug in the AC power plug. |
plugged in. |
|
|
• The Disc Lock function is in use. |
| • Turn off the Disc Lock function. |
|
| (See page 25.) |
|
|
|
The CD does not play.
The CD skips.
If “DIGITAL IN UNLOCK” appears in the main display.
If “NO OPERATE!” appears in the main display.
If “CAUTION!” appears in the main display.
The CD is upside down.
The CD is dirty or scratched.
There is no digital device connected to the DIGITAL IN terminal.
Operation you have done is not acceptable. For example, you are trying to use both the remote control, and the buttons and controls on the unit while entering disc or track titles.
Something is wrong with your unit.
Put the CD in with the label side up.
Clean or replace the CD. (See page 65.)
Connect a digital device using digital optical cord. (See page 8.)
Follow the correct procedure explained in this manual.
Unplug the unit immediately, then consult your dealer.
The display suddenly becomes dark.
Operations are disabled.
This happens because a strong light |
| Avoid exposing the unit to a strong |
strikes the display. |
| light. |
|
|
|
The |
| Press CANCEL and DISC on the unit at |
malfunctioned due to external electrical |
| the same time to reset the |
interference. |
| microprocessor, or unplug the unit then |
|
| plug it back in. |
