NOW, you can plug in the unit and other connected equipment FINALLY!
VOLTAGE SELECTOR
127V
230 -
110V240V
220V
RIGHT LEFT
SPEAKERS
CAUTION:
SPEAKER | IMPEDENCE 6 16Ω |
To a wall outlet
If the AC power plug does not match the wall outlet, use the supplied AC plug adaptor.
When connecting the AC power cord into a wall outlet, the unit automatically starts display demonstration.
To stop and cancel the display demonstration, press ENTER/DEMO during display demonstration. “DEMO OFF!” appears in the main display, the unit is turned off, then the display dims.
After canceling the display demonstration, it will start only when the AC power cord is reconnected or when a power failure is recovered.
•Pressing some of the buttons on the unit or the remote control will stop the demonstration temporarily.
If you do not cancel the display demonstration, it will start automatically in the following cases
•2 minutes after the unit is turned off.
•When no operation is done for more than 2 minutes after the unit is turned on.
If you do not want to start the display demonstration when the AC power cord is reconnected or when a power failure is recovered
See “To store the display setting in memory” on page 15.
To start the display demonstration manually
Press ENTER/DEMO.
•Each time you press the button, the display demonstration turns on and off.
During MD editing and title entry mode
The ENTER/DEMO button cannot function for the display demonstration.
Putting the Batteries into the Remote Control
Insert the batteries —
remote control, by matching the polarity (+ and
When the remote control can no longer operate the unit, replace both batteries at the same time.
1
2
3
• DO NOT use an old battery together with a new one.
•DO NOT use different types of batteries together.
•DO NOT expose batteries to heat or flame.
•DO NOT leave the batteries in the battery compartment when you are not going to use the remote control for an extended period of time. Otherwise, it will be damaged from battery leakage.