Finisar FTLX1341E2 manual Product Specification RoHS-6 Compliant 10GBASE-LRM X2 Transponder

Product Specification

RoHS-6 Compliant

10GBASE-LRM X2 Transponder

FTLX1341E2

PRODUCT FEATURES

ƒHot pluggable X2 MSA form factor

ƒTotal power consumption: 4.0 W maximum

ƒRoHS-6 compliant (lead-free)

ƒTemperature range 0°C to 70°C

ƒTransmission distance up to 220m*

ƒUncooled 1310 nm directly modulated Fabry-Perot (FP) laser

ƒBuilt In Advanced Electronic Dispersion Compensation (EDC)

ƒSC connector, multimode fiber

ƒFull duplex transmission mode

ƒDigital Optics Monitoring (DOM)

ƒPower supply: +5.0 V, +3.3 V

ƒAdaptable Power Supply (APS: +1.2 V)

ƒXAUI electrical interface

- 4 x 3.125 Gb/s Ethernet

ƒManagement and control via MDIO 2-wire bus

ƒ70-pin connector

ƒSeparated signal/chassis ground

ƒMid Pak module variance for front panel mounting

ƒDe-latch mechanism with low extraction force

APPLICATIONS

ƒIEEE 802.3aq-2006

ƒ10 Gb/s Ethernet transmission on legacy multimode fiber.

The Finisar FTLX1341E2 transponder incorporates Electronic Dispersion Compensation (EDC) which provides correction for the severe modal dispersion that may occur during propagation through links up to 220m on legacy installed FDDI multimode fiber. The EDC device incorporates a Feed Forward Equalizer (FFE) and a Decision Feedback Equalizer (DFE). The EDC also contains sophisticated clock recovery architecture for extracting a robust clock from extremely distorted signals.

PRODUCT SELECTION

FTLX1341E2

* Maximum reach as defined by IEEE. Longer reach possible depending upon link implementation.

© Finisar Corporation – October 2008 Rev B Page 1