BASIC OPERATION
RECORDING
CCTV Resolution
CCTV resolution is measured in vertical and horizontal pixel dimensions and typically limited by the capabilities of both the camera and the recorder that you are using for your CCTV surveillance installation. CCTV systems use an analog video signal. For television specifications (which CCTV uses) the highest resolution that can be captured and stored
is 704 x 480 (NTSC for the United States) and 720 x 576 (PAL for Europe). This resolution is known as D1 resolution. A high end CCTV recorder is capable of recording at up to D1 resolution.
Region CoverREGION COVER lets you block a specific portion of a channel you do not want recorded or shown on the display screen. This can be useful if you need to conceal a sensitive area being captured by the camera. To use the REGION COVER:
1.From record menu click REGION COVER. The REGION COVER menu opens.
2.Choose a channel you wish to apply the Region Cover.
3.Select ON from the SWITCH
4.Click SET in REGION COVER. The screen will be replaced by the full- screen camera view of the desired channel. Using the mouse, place the cursor just outside the region cover square. Click and drag the black square with your cursor to place and size the area you wish to conceal. Up to 4 separate cover areas are available to set.
5.
6.Click OK. Click OK in the RECORD window. Click EXIT.
Motion Detect SetupYou can configure motion detection for each channel (Camera) connected to the DVR. To configure motion detection:
1.From the Main Menu click ADVANCED. Then click Motion Detect.
2.Under STATUS, select ON to enable motion detection for the desired channel. Click NEXT PAGE for additional channels.
3.Under SENSITIVITY, select from the LOWEST setting to the HIGHEST sensitive setting.
4.Under REGION, click SET. The red motion detect grid appears over the selected channel in full screen.
5.Click the blocks in the grid to enable/disable motion detection. Red=motion detection enabled; White=motion detection disabled.
6.
7.The DELAY, setting will cause the recording to continue after motion stops for the number of seconds selected.
8.SHOW MESSAGE ON will display the alarm status when motion is detected.
9.SEND Email enables/disables sending an email alert if desired. Email must be configured.
10.BUZZER enable the DVR to sound or not sound if motion is detected. Click NEXT PAGE to set additional camera channels.
11.Click OK to save settings.
CCTV Resolutions D1: 704 x 480
HD1 (2CIF): 704 x 240
CIF: 352 x 240
QCIF: 176 x 120
Region CoverMotion Detect Menu
Motion Detect Grid
Page 19