8
Installation instructions
Fastening the installation brackets (Fig. 4a and 4b)
Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop to benches from 20 to 40 mm thick.
Turn the cooktop upside down, place it on a soft surface and fasten the brackets “F and R” (CG604 models) or “A” (CG905 models) to the appropriate socket holes, without tightening the screws “B” for the moment (see Figs. 4a and 4b).
Fastening the cooktop (Figs. 4a and 4b)
1Spread the sealing material “C” out along the edge of the cutout, making sure that the junctions overlap at the corners.
2Insert the cooktop into the cutout and position it correctly.
3Adjust the position of the brackets “F and R” (CG604 models) or “A” (CG905 models) and tighten screws “B” to secure the cooktop firmly in position.
4Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop. Take care not to damage the workbench.
R
Gas inlet pipe
R
Fig. 4a CG604 models -
Fastening the installation brackets and the cooktop
B
F
Rear side | Front side |
|
C
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
20 mm min. | 40 mm max. |
|
|
Gas inlet pipe
A
Fig. 4b CG905 models -
Fastening the installation brackets and the cooktop
| F | C |
|
|
|
|
|
|
|
| |
|
|
|
|
| 0 |
|
|
|
| – 2 | |
|
|
| min. | max. | 0 |
|
| B |
| – 2 | |
R |
| 20mm | mm40 |
| |
| F |
| |||
B |
|
|
|
|
|
A |
|
| C |
|
|
|
|
|
|
| |
A |
|
|
|
|
|
|
| A |
|
|
|
A |
| B |
| min. | max. |
|
| A |
| mm | mm |
A |
|
|
| 20 | 40 |
|
|
|
|
|