Fisher & Paykel CG905 Troubleshooting chart, Problem, Possible solutions

26

Troubleshooting

Troubleshooting chart

Problem	Possible solutions
A burner does not light	Check the cooktop is plugged in and the electricity is switched on.
	Check the gas supply valve is turned on and the supply to the
	house is working. You should hear the gas when you turn a burner
	on.
	Check the gas bottle is not empty.
	The ignitors may be dirty. Clean them with a toothbrush and
	methylated spirits.
	The burner parts may not be located properly. Check the assembly
	and make sure the burner cap is sitting flat.
My burner flames are	The burner parts may not be located properly. Check the assembly
yellow or hard to start	and make sure the burner cap is sitting flat.
	If you use bottled gas, this may indicate you are getting near the
	end of the bottle.
	Check the burner parts are clean and dry.
	The gas pressure may not be at the correct level. Check with your
	service person or installer.
	Your cooktop may not be set up for the gas you are using. Check
	this with your service person or installer.
One of my burners has an	Check the burner parts are clean and dry. Check the assembly and
uneven flame	make sure the burner cap is sitting flat.
The flame goes out at low	The gas supply pressure may be low. Check this with your service
settings	person or installer.
	The low setting may have been adjusted incorrectly. Check this
	with your service person or installer.
	If you use bottled gas, this may indicate you are getting near the
	end of the bottle.

My burners do not turn down much (when running on bottled gas or LPG)

Your cooktop may not have been adjusted correctly. Check this with your service person or installer.

The flame tips are very yellow

Call your service person to service the cooktop.

There are objectionable Call your service person to service the cooktop. odours

The flame appears to lift off the burner

Call your service person to service the cooktop.

There is an electricity	If there is an electricity failure, you can still use your cooktop.
failure	Light the burners by holding a match close to the side of the
	burner and turning the control knob to the High position. Wait
	until the flame is burning evenly before adjusting.