INTEGRATED MODELS ONLY - INSTALLING THE FRONT PANELS | 18 |
16REMOVE BRACKETS FROM PRODUCT
WARNING!
Electrical Shock Hazard
Before continuing, ensure that the product is disconnected from the power supply.
Failure to follow this warning may result in electrical shock, injury or fire.
1
2
1
3
17ATTACH PANELS TO PANEL BRACKETS
1 | 2 | There must be at least |
5⁄8” (16mm) x6 | ||
|
| 3 screws used each side |
Important!
Break off and discard the tab at the top of the Lower Panel Bracket.
3
Align bottom of panels with bottom of brackets
18GROUND THE PANELS
19ATTACH PANELS TO PRODUCT
| Important! | |
| Ensure the rubber seal | |
2 | between the drawer | |
and panels is kept in | ||
| ||
| place. |
1
Repeat for the other drawer
WARNING!
Electrical Shock Hazard
To ground (earth) the panel bracket, connect the ground (earth) wire from the product to one of the tabs. Any custom metal component (e.g. handle) that extends past the rubber seal must be grounded (earthed) too.
Failure to follow these warnings may result in electrical shock, injury or fire.
2
Repeat for the other drawer
When refitting the door pins, ensure they are orientated as shown.