|
| Troubleshooting | 27 |
|
|
| |
Problem | Possible Cause | What to do |
|
|
|
|
|
Continuous | A fault has occurred. | Refer to the ‘Fault codes’ section. |
|
beeping |
|
|
|
|
|
|
|
Intermittent | DishDrawer® is in pause | Close the DishDrawer® and press the |
|
beeping | mode. | button. |
|
|
|
|
|
DishDrawer® will | Power supply is not | Connect the power supply. |
|
not start | connected. |
|
|
The drawer is not closed properly.
Ensure the drawer is firmly closed.
| Keylock or Childlock feature | Turn the Keylock or Childlock off. Hold down | ||
| is on. | the | / | button until the light above the |
|
| / | button disappears. | |
| button not pressed. | Press the | button. | |
Water under the | This is normal and needs no action. |
|
| |
drain filter |
|
|
|
|
Excess water in the | Drain hose bent or kinked. | Straighten the drain hose. | ||
DishDrawer® | Blocked filters. | Clean the drain filter. Refer to the ‘User | ||
| ||||
|
| maintenance instructions’ section. | ||
Water marks on the | Rinse aid depleted. | Refill the rinse aid dispenser. | ||
dishes | Rinse aid setting too low. | Increase the rinse aid setting. | ||
| ||||
|
|
| ||
| DishDrawer® overloaded/ | Refer to the section on loading. | ||
| incorrectly loaded. |
|
|
|
DishDrawer® | Some foods, like tomato | |||
interior is stained | based products, may | DishDrawer®. Alternatively, using the Rinse | ||
| stain the inside of the | programme after adding the dishes may | ||
| DishDrawer®. | minimise staining. | ||
Dishes did not dry | Incorrect loading. | Ensure the dishes are not nesting together. | ||
|
|
| ||
| Rinse aid depleted. | Refill the rinse aid dispenser. | ||
|
|
| ||
| Rinse aid setting too low. | Increase the rinse aid setting. | ||
|
| |||
| Eco wash programme used. Choose a standard wash programme. | |||
|
|
| ||
No detergent | Detergent dispenser was | Clean the dispenser and ensure the dispenser | ||
dispensed | wet when loaded. | is dry when adding detergent. | ||
|
|
| ||
Excessive motor | The spray arms are | Refer to the ‘User maintenance instructions’ | ||
noise | incorrectly placed. | section for details on correct placement. | ||
|
|
| ||
| No water in the motor area. | This usually occurs on the first use or when | ||
|
| the DishDrawer® has not been used for |
long periods of time. Run the DishDrawer® through a wash programme.