Fisher & Paykel OB24SDPX Timer, Semi-Automatic Cooking, Setting, During cooking

3

	I	I
￿	I	I
	I
		I
1		5	6

TIMER

The timer function is only used to count the time and does not influence oven operation or any program which are in progress or set.

1.Press push button 1. The bell symbol will start to flash.

2.Press keys 5 or 6 to set the time required.

3.The countdown starts immediately. The bell symbol stops flashing and the time appears again.

4.To see the countdown press push button 1. The time will be indicated in hours and minutes; the seconds are only indicated for the last minute.

5.At the end of the countdown an audible signal sounds and the bell symbol on the display flashes.

Press any push button to stop the audible signal.

IMPORTANT WARNING: This function is only an electronic alarm and does not switch OFF the oven. Remember to turn OFF manually the selector knob at the end of the countdown.

SEMI-AUTOMATIC COOKING

Start immediate cooking and switch the oven off automatically after the programmed cooking time.

Setting

I	I
I	I
I
I	I
I	I

2

I	I	I
		I
I		I
I		I
I
		I
I
	I	I

5 6

1.Set the cooking function by turning the oven selector to the function required.

2.The cooking temperature appears on the display. To change it proceed as described in the “Setting the cooking” section.

3.Press push button 2. AUTO starts to flash and 0.00 appears.

4.Press push buttons 5 or 6 to set the cooking time (cooking time in hours and min- utes: set it to ten minutes less than the time required because the stored heat will complete the cooking).

5.On the display AUTO becomes steady and the cooking program starts.

During cooking

6.During the cooking cycle, the display shows the oven temperature measured by the probe or pre-set temperature.

Press key 2 to display the time remaining until the end of cooking.

The cooking time and temperature can be varied at any time, as described above.

At the end of cooking

I	I
	I
I	I
I	I
I	I
II

18

7.End appears on the display, AUTO flashes and the audible signal sounds. The cooking cycle has finished and the oven is OFF.

8.Press any program push button to stop the audible signal.

9.OFF appears (oven OFF).

10.Turn the function selector to 0 (OFF).

11.The program display shows the time.

Note: At the end of the program always turn the function selector knob to 0 (OFF).