Fisher & Paykel OR60 installation instructions Cooktop troubleshooting, Problem

Models: OR60

1 32
Download 32 pages 4.57 Kb
Page 23
Image 23
Cooktop troubleshooting

Cooktop troubleshooting

Problem

Possible solutions

21

My cooktop burners do not light

Check the cooker is switched on.

 

Check the gas supply valve is turned on and the

 

supply to the house is working. You should hear the

 

gas when you turn a burner on.

 

The ignitors may be dirty. Clean them with a

 

toothbrush and methylated spirits.

 

The burner parts may not be located properly. Check

 

the assembly and make sure the burner cap is sitting

 

flat.

 

 

My burner flames are yellow or hard to start

The burner parts may not be located properly. Check the assembly and make sure the burner cap is sitting flat.

If you use bottled gas this may indicate you are getting near the end of the bottle.

Check the burner parts are clean and dry.

The gas pressure may not be at the correct level. Check with your service person or installer.

Your cooker may not be set up for the gas you are using. Check this with your service person or installer.

One of my burners has an uneven

Check the burner parts are clean and dry. Check the

flame

assembly and make sure the burner cap is sitting flat.

The flame goes out at low settings

The gas supply pressure may be low. Check this with

 

your service person or installer.

 

The low setting may have been adjusted incorrectly.

 

Check this with your service person or installer.

 

 

My burners do not turn down much (when running on bottled gas or LPG)

Your cooktop may not have been adjusted correctly. Check this with your service person or installer.

The flame tips are very yellow

Call your service person to service the cooker.

 

 

There are objectionable odours

Call your service person to service the cooker.

The flame appears to lift off the burner

Call your service person to service the cooker.

There is an electricity failure

If there is an electricity failure, you can still use your

 

cooktop. Light the burners by holding a match close

 

to the side of the burner and turning the control

 

knob to the High position. Wait until the flame is

 

burning evenly before adjusting.

Page 23
Image 23
Fisher & Paykel OR60 installation instructions Cooktop troubleshooting, Problem