Fisher & Paykel OR90SDBGFX Fitting the anti-tilt bracket, To fit the anti-tilt bracket

Installation instructions

Fitting the anti-tilt bracket

9

Important!

To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the anti-tilt bracket.

65 mm

898 mm (product width) 833 mm

If installing the cooker above a plinth (without fitting the adjustable feet), revise the installation dimensions accordingly considering that the feet have the following measures: min 155 mm - max 180 mm.

To fit the anti-tilt bracket:

1After you have located where the cooker is to be positioned, mark on the wall the place where the two screws of the anti-tilt bracket have to be fitted. Please follow the indications given in Fig10a.

2Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.

0 + 25

min 210 mm max 235 mm

(depending on feet adjustment)

Fig. 10a Fitting the anti-tilt bracket

Important!

Before drilling the holes, check that you will not damage any pipes or electrical wires.

3Loosely attach the anti-tilt bracket with the two screws supplied.

4Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can engage in the slot on the cooker’s back, as shown in Fig.10a.

5Tighten the screws attaching the anti-tilt bracket.

6Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot on the cooker’s back.

7Access the bracket and fit the lock pin;

Open the pivoting panel (Fig. 10b). Fit the lock pin through the bracket, as shown (Fig.10c).

Close the pivoting panel.

	Pivoting
	panel
	Fig. 10b Opening the pivoting panel
1	Anti-tilt bracket
	attached on the
	rear wall
	Cooker’s
	back
Lock pin

Slot on the cooker’s back

2

Lock pin correctly fitted

Fig. 10c Fitting the lock pin through the bracket