Fisher & Paykel OR90SDBGFX Before using your cooktop, Using the gas burners

Using your gas cooktop

Before using your cooktop

27

Before using your new cooktop, please:

Read this user guide, taking special note of the ‘Safety and warnings’ section. Turn the power to the cooker on at the wall.

Make sure all burner control dials are turned off.

Using the gas burners

1Choose the control dial for the burner you want to use.

2Semi-rapid and triple-ring burners: press the dial in gently and turn it anticlockwise to the

position. The ignitors on all the burners will spark.

Dual burner: press the dial in gently and turn it anticlockwise to the position (to ignite the

inner and outer crowns) or press the dial it gently and turn it clockwise to the position (to ignite the inner crown only). The ignitors on all the burners will spark.

Hold in the dial for approximately 10 seconds after the burner has lit. Releasing the dial too soon will extinguish the flame.

3Adjust the flame anywhere between and or and or and positions. Do not

adjust the flame between or or and 0 (OFF).

Note: If the burner does not light within 15 seconds, turn the control dial off and wait at least one minute before trying again.

4To turn the burner off, turn the dial clockwise (semi-rapid and triple-ring burners or dual burner when using both crowns) or anticlockwise (dual burner when using the inner crown only) to 0 (OFF) until you hear the safety click.

5After use, always turn the dials to the 0 (OFF) position.

Flame failure safety feature

The flame failure probe cuts off the gas supply to the burner if the flame is blown out. When lighting the burner on flame failure models, hold down the dial for approximately 10 seconds after the burner has lit. Releasing the dial too soon will extinguish the flame.

If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least one minute (to allow the gas to disperse).