Before you start using your Ice & Water refrigerator
15
US CA
■■Check refrigerator is switched on and has cooled for at least 2 hours before use (refer to page 19 – The temperature of your refrigerator and freezer).
■■Check that the water filter has been connected and turned on.
■■Turn on the ice maker (refer to page 24).
■■At first use allow approximately a minute from when the dispensing pad is pushed until water is dispensed. This will allow the tank to fill.
■■Run through and discard the first 3 qt (3 L) of water from the dispenser, stopping intermittently (refer to page 21 – First use). Failure to do this will result in excessive dripping from your dispenser.
■■Discard the first 3 harvests of ice (8 cubes are produced per harvest), refer to page 24 – First use. You are now ready to enjoy ice and water from your ActiveSmart™ refrigerator.
Fig.15 Water dispenser
Please note that once installation is complete a few drips may appear out of the dispenser over the next few days as the remaining trapped air is cleared.
