Fisher & Paykel RX256DT7X1 installation instructions Handle Removal, Installation

INSTALLATION

6. Pull on tubing to confirm connection is secure.

Connect tubing to frame
with water tubing clamp
(C) and turn on water
supply. Check for leaks
and correct if necessary.
Continue to observe the	C
water supply connection
for two to three hours
prior to moving the
refrigerator to its
permanent location.

7 . Monitor water connection for 24 hours. Correct leaks, if necessary.

Handle Removal

Handles are installed at the factory.

Materials Needed:

• 4 mm ( 5⁄32” ) Allen wrench

To Remove:

•Remove cap-screw from handle mounting post using 4 mm ( 5⁄32” ) Allen wrench.

•Repeat the procedure on all posts to remove the handle.

To Replace:

•Align handle with the mounting posts.

•Fully tighten all cap-screws to secure handle in place.

7