Fisher & Paykel RX256DT7X1 Temperature Controls, Trisensor Climate Control, Adjusting the Control

TEMPERATURE CONTROLS

Trisensor Climate Control

The control is located at the top front of the fresh food compartment.

Initial Temperature Setting

Temperatures are preset at the factory at 38° F (3° C) in the fresh food compartment and 0° F (-18° C) in the freezer compartment.

Adjusting the Control

24 hours after adding food, you may decide that one or both compartments should be colder or warmer.

If so, adjust the control as indicated in the Temperature Control Guide below.

•The first touch of the W or V pads shows the current temperature setting.

•The display will show the new setting for approximately three seconds, and then return to the actual temperature currently within that compartment.

•Do not change either control more than one degree at a time. Allow temperature to stabilize for 24 hours before making a new temperature adjustment.

Temperature Control Guide

Refrigerator too cold	Set the Refrigerator control
	to next higher number by
	pressing the V pad.
Refrigerator too warm	Set the Refrigerator control
	to next lower number by
	pressing the W pad.
Freezer too cold	Set the Freezer control to
	next higher number by
	pressing the V pad.
Freezer too warm	Set the Freezer control
	to next lower number by
	pressing the W pad.
Turn refrigerator OFF	Press the Freezer V pad
	until OFF appears in the
	display. Press either the
	Freezer or Refrigerator W
	pad to turn back on.

Speed Ice

When activated, Speed Ice reduces the freezer temperature to the optimum setting for 24 hours in order to produce more ice. Important: When the Speed Ice feature is in operation, the V and W pads for the Freezer control will not operate.

Reset Filter

When a water filter has been installed in the refrigerator, the yellow Order light will illuminate when 90% of the volume of water for which the filter is rated has passed through the filter OR once 11 months have elapsed since the filter has been installed.

The red Replace light will illuminate when the rated volume of water has passed through the filter OR 12 months have elapsed since the filter was installed.

A new filter should be installed immediately when the Replace light is illuminated.

After replacing the filter, press and hold the Reset Filter pad for two seconds. The Order and Replace lights will go off.

Vacation Mode

The Vacation Mode feature causes the freezer to defrost less frequently, conserving energy. The Vacation Mode indicator light will illuminate when the feature is activated. To deactivate, press the Vacation Mode pad again OR open either door. The indicator light will go out.

Notes :

•Door openings will not deactivate Vacation Mode for approximately one hour after activation.

•If vacationing for more than a few days, see the Preparing for Vacation section, page 26.

Temp Alarm

The Temp Alarm system will alert you if the freezer or fresh food temperatures exceed normal operating

Cont.

8