CONNECTING THE PROJECTOR
COMPUTER IN
Terminal :
Connect the display output terminal of the computer to the projector with the VGA Cable (supplied). When connecting the Macintosh computer the MAC/VGA Adapter is required.
Pin Configuration
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
1 | Red Input | 9 | Non Connect |
2 | Green Input | 10 | Ground (Vert.sync.) |
3 | Blue Input | 11 | Sense 0 |
4 | Sense 2 | 12 | Sense 1 |
5 | Ground (Horiz.sync.) | 13 | Horiz. sync. |
6 | Ground (Red) | 14 | Vert. sync. |
7 | Ground (Green) | 15 | Reserved |
8 | Ground (Blue) |
|
|
|
|
|
|
CONTROL PORT
Pin Configuration
Terminal : |
|
|
|
|
When controlling the computer |
|
|
|
|
with the projector's Wireless |
| 2 | 1 |
|
Remote Control Unit, connect | 6 | 5 | 4 | 3 |
control port (PS/2, Serial or ADB | 10 | 9 | 8 | 7 |
| ||||
port) on your computer to this |
| 12 | 11 |
|
|
|
|
|
terminal. (Three types of cables are supplied.)
NOTE : The R X D port (5th pin on the Serial Port is provided on Control Port 1 only. If your control the projector by computer you must connect Control Port 1 connector.
| PS/2 | Serial | ADB |
1 | T X D | ||
2 | CLK | ADB | |
3 | DATA | ||
4 | |||
5 | R X D | ||
6 | |||
7 | READY | ||
8 | |||
9 | GND | GND | GND |
10 | |||
11 | |||
12 | |||
|
|
|
|
VIDEO IN
VIDEO / Y
Connect the Composite Video output, or the Y signal output from the Component Output Video equipment (like DVD player) to this terminal.
C / Cb
Connect the C component or Cb component signal output from the Component Output Video equipment to this terminal.
Cr
Connect the Cr component signal output from Component Output Video equipment to this terminal.
BNC
Connect the Composite Video output from the BNC terminal to this terminal. When connecting to this terminal, do not connect any input source to the VIDEO terminal.
AUDIO R / L
Connect the Audio output to this terminal. When the audio output of the audio equipment is stereo, be sure to connect the right and left channels to the respective right and left jacks. And when the audio input of the audio equipment is monaural, connect it to the left jack.
CAUTION
When connecting the peripheral equipment to the projector, please observe the following precautions:
lBe sure that the each equipment is turned off.
lConnect the cable securely to the respective terminal.
lWhen removing the cable, never pull the cord. Hold the plug of the cable and remove it.
lWhen operating the peripheral equipment, turn off the other equipment that is not used.
13