COMPUTER MODE

PC ADJUSTMENT

This Projector can automatically detect display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be detected by this projector. If this happens, the projector cannot reproduce a proper image and the image is recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.

This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match with the input signal format. The projector has eight independent memory areas where you can store the parameter you have set. This enables you to recall the setting for a specific computer whenever you need it.

1 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select PC ADJUST and press the SELECT (REAR CLICK) button. Another dialog box "Where to reserve" Menu will appear.

2 In this dialog box, you can store the parameter into the area from "Mode 1" to "Mode 8." When memorizing the new computer parameter, select the Mode with the message of "Free" by pressing the POINT UP/DOWN buttons and SELECT button. To change the parameters of the Mode previously set, select the Mode with "Stored."

3 When the Mode is selected, Parameter adjustment dialog box

appears. Adjust the each item to match with your computer.

Total lines The number of the total vertical lines. Adjust the number to match your PC image.

Total dots The number of the total dots in one horizontal period.

Adjust the number to match your PC image.

Horizontal Adjustment of the horizontal picture position. When the image is not centered on the screen, adjust this item.

Vertical Adjustment of the vertical picture position. When the image is not centered on the screen, adjust this item.

Clamp Adjustment of the clamp level. When the image has a dark bar(s), try this adjustment.

Height Adjusting the vertical height of the picture image.

Width

 

Adjusting the horizontal width of the picture image.

 

 

 

4 When the parameter data adjustment finishes to be set, select "Stored" and press the SELECT (REAR CLICK) button. "OK?" dialog box is displayed for confirmation.

5 To select the Mode manually adjusted in PC ADJUSTMENT Menu, select the mode at the SYSTEM SELECT Menu. (Refer to page 27.)

Reset

It recall the parameter data that previously adjusted.

 

 

Mode free

It clear the parameter data previously set the selected

 

Mode.

 

 

Stored

It stores the parameters in the memory.

 

 

Quit

It terminates the PC ADJUST Menu.

 

When the Mode is

 

Stored

selected, below

 

display appears.

 

 

 

Stored

 

 

Stored

This Mode has

 

 

 

 

parameters being

 

 

stored.

 

 

The Vacant Mode.

 

 

Manual set Computer

 

 

Mode (1 to 8).

 

 

It terminates the PC

 

 

ADJUSTMENT

 

 

Menu.

Mode 4 Free

Move the arrow to or and press SELECT (REAR CLICK) button.

Press SELECT (REAR CLICK) button at this item to adjust "Clamp," "Height," "Width."

28