COMPUTER MODE
Auto Image Function
The Auto Image function is provided to automatically adjust Fine sync., Total dots, and Picture Position for most computers.
1 | Press the MENU button and the |
| Press the POINT LEFT/RIGHT buttons to select AUTO IMAGE |
| and press the SELECT (REAR CLICK) button. |
| |
| Another dialog box AUTO IMAGE Menu will appear. |
2 | Move the arrow to an item that you want to adjust by pressing the |
| POINT UP/DOWN button. Change the setting On or Off by |
pressing the SELECT button.
Fine sync Adjust the picture as necessary to eliminate flicker from the display. This item can be adjusted manually. (Refer to page 30.)
Total Dots The number of the total dots in one horizontal period. This item can be adjusted manually. (Refer to page 30.)
Position Adjustment of the position of the image. This item can
be adjusted manually. (Refer to page 32.)
3 | Move the arrow to "Go!" and press the SELECT (REAR CLICK) |
| button to start the Auto Image function. |
|
|
NOTE : The Fine sync., Total dots, and Picture Position of some computers may not be fully adjusted with the Auto Image Function. In that case, manually adjustments is required to make fine image. (Refer to PICTURE IMAGE ADJUSTMENT on page 30 to adjust "Fine sync." or "Total dots" and PICTURE POSITION ADJUSTMENT on page 32 to adjust Picture Position.
Move the arrow to the item and then press the SELECT (REAR CLICK) button.
It starts the adjustment on the item set to "On".
It terminates the
PICTURE IMAGE ADJUSTMENT Menu.
Normal Function
The normal picture level is preset on this projector by the factory and |
|
can be restored anytime by pressing the NORMAL button (located on |
|
the Front Control or on the Remote Control Units). The "Normal" | Normal |
display will be displayed on the screen for a few seconds. |
31