BASIC OPERATION

TURNING ON / OFF THE PROJECTOR

Turning on the Projector

1

Connect the peripheral equipment (Computer, VCR, and etc.)

 

before turning on the projector. (Refer to "CONNECTING TO

 

THE PROJECTOR" on Pages 10~15 for connecting those

 

equipment.

2

Connect the projector's AC power cord into a wall outlet and turn

 

the MAIN ON/OFF switch (located on the Front Control) to the ON

 

position. The LAMP POWER indicator lights RED, and the

 

READY indicator lights GREEN.

3

Press the power ON/OFF button on the Remote Control Unit or on

the projector to ON. The LAMP POWER indicator dims, and the Cooling Fans start to operate. The Preparation Display appears on the screen and the count-down starts. The signal from the source appears after 30 seconds.

30

The Preparation Display disappears after 30 seconds.

 

Turning off the Projector

1

Press the power ON/OFF button on the Remote Control Unit or on

 

the Front Control, and the message "Power off?" appears on the

 

screen.

2

Press again the power ON/OFF button to turn off the projector.

 

The LAMP POWER indicator lights bright and the READY

 

indicator turns off. The Cooling Fans operate for 1 minute after

 

the projector is turned off. (During this "Cooling Down" period, this

 

appliance cannot be turned on.)

3

When the cooling the projector has finished, the READY indicator

turns to green again and you can turn the projector on. To power down completely, turn the MAIN ON/OFF switch to the OFF position.

THIS PROJECTOR USES AN UHP LAMP. TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU TURN IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.

When the TEMPERATURE WARNING indicator flashes red, the projector is automatically turned off. Wait at least 5 minutes before turning the projector on again.

If the TEMPERATURE WARNING indicator continues to flash, follow procedures below:

1.Press the power ON/OFF button to OFF.

2.Check the air filters for dust accumulation.

3.Remove dust with vacuum cleaner. (See "AIR FILTER CARE AND CLEANING" section on page 46.)

4.Press the LAMP POWER ON/OFF button to ON.

If the TEMPERATURE WARNING indicator still continues to flash, call your authorized dealer or service station.

Power off?

The message disappears after 4 seconds.

24