Basic Operation
Turning Off the Projector
1 | Press the POWER |
|
|
|
|
| or on the remote control. “Power off?” appears on the |
|
|
|
|
| screen. Press the POWER |
|
|
|
|
| turn off the projector. |
|
|
|
|
|
|
|
|
| |
| When the Power off confirmation function is set to “Off,” |
|
|
|
|
|
|
|
|
| |
| the projector can be turned off without the confirmation |
|
|
|
|
| message. (See “Power off confirmation” on page 38.) |
|
|
|
|
|
| “Power off?” disappears after 4 seconds. | |||
| The automatic slide shutter closes and the POWER indicator | ||||
| starts to blink red. The blinking continues for about 60 | ||||
| seconds while the cooling fans are running. | ||||
2 | When the projector is cooled down enough to be turned on | ||||
again, the POWER indicator becomes red. Then you can turn the Main On/Off switch off and unplug the AC power cord.
TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR
ON, WAIT AT LEAST FIVE (5) MINUTES BEFORE TURNING IT
OFF.
DO NOT UNPLUG AC POWER CORD WHILE COOLING FANS
ARE RUNNING OR BEFORE POWER INDICATOR STOPS
BLINKING. OTHERWISE IT WILL RESULT IN SHORTENING
LAMP LIFE.
✔Notes:
•If the automatic slide shutter is closed during operation, the projector is automatically turned off for safety. Be sure to turn off the projector by pressing the POWER
•While the POWER indicator is blinking, the lamp is being cooled down and the projector cannot be turned on. Wait until the POWER indicator becomes red to be turned on again.
•Do not operate the projector continuously without rest. Continuous use may result in shortening the lamp life. Turn off the projector and let stand for about an hour in every 24 hours.
•The running speed of cooling fans is changed according to the temperature inside the projector.
•If the WARNING indicator blinks or emits red light, see “Warning Indicator” on page 42.
•Do not put the projector in a case before it is cooled enough.
19