INSTALLATION
LOCATING YOUR
GAS STOVE
When selecting a location for your stove, ensure that the clearances listed above are met as well as ensuring that there is adequate accessibility for servicing and proper operation.
OPTIONAL FAN
INSTALLATION
Fan Kit Contains:
Qty. Description
1Fan Assembly c/w green wire attached
1Thermodisc
1power cord
2
1 Fan Speed Control
1)Remove the rear access panel on the back of the stove by removing the 2 screws under the rear panel, then lift off the 2 screws at the top. Take care not to cut wires when lowering the panel.
4)Remove the nylon hole plug from the control panel.
5)Install the fan speed controller onto the control panel and secure with nut and washer. Connect the red and black wires from the wire harness to speed controller.
NOTE: Speed control wires must be in the down position when control panel is in place.
6)Push black knob onto speed control.
Fan Speed
Controller
A)Cross Corner
B)Room Divider
C)Island
D)Flat on Wall
E)Flat on Wall Corner
F)Flush with Wall/Alcove
For Vent Termination requirements, see "Exterior Vent Terminal Locations" section.
MANUFACTURED
MOBILE HOME
ADDITIONAL
REQUIREMENTS
1)Ensure that structural members are not cut or weakened during installation.
2)Ensure proper grounding using the #8 ground lug provided.
3)Appliance must be anchored to the fl oor with the supplied anchoring methods.
COMBUSTION AND VENTILATION AIR
The combustion air from this appliance is drawn from outside the building through the outer fl ue.
Extra provision for combustion air inside the room is not required.
screwscrew
screw
Lift Rear Panel off the 2 top screws
2)Disconnect the red and grey wires.
3)Remove the Top Control Panel Assembly by removing the three screws.
7)
8)Slide Thermodisc into the bracket on the left side of the rear fi rebox.
Thermodisc Thermodisc
Braket
Top Control Panel Assembly
8 | Hampton® |
