OPERATING INSTRUCTIONS
OPERATING
INSTRUCTIONS
located at the top right hand corner (rear) of | windows to ventilate the room for a couple of |
the stove. | hours. The glass may require cleaning. |
1)Read and understand these instructions before operating this appliance.
2)Check to see that all wiring is correct and enclosed to prevent possible shock.
3)Check to ensure there are no gas leaks.
4)Make sure the glass in the door frame is properly positioned. Never operate the ap- pliance with the glass removed. Never strike the glass.
5)Verify that the venting and cap are unob- structed.
6)Verify log placement. If the pilot cannot be seen when lighting the unit - the logs have been incorrectly positioned.
7)The unit should never be turned off, and on again without a minimum of a 60 second wait.
2)Turn gas control knob so indicator points to "OFF" position and allow 5 minutes for any gas in the combustion chamber to escape.
3)Turn gas control knob counterclockwise so indicator points to the "PILOT" position. Depress the gas control knob fully. Depress the igniter button several times until the pilot lights. After approximately one minute, release the gas control knob.The pilot fl ame should continue to burn. If the pilot does not remain lit, repeat operation allowing a longer period before releasing gas control knob.
4)When the pilot stays lit, turn the gas knob further counterclockwise to the "ON" posi- tion.
5)Use the thermostat or remote control to turn on the unit.
6)Rotate the fl ame height regulator to adjust the fl ame height higher or lower.
DO NOT ATTEMPT TO CLEAN THE GLASS WHILE IT IS STILL HOT!
Note: When the glass is cold and the appli- ance is lit, it may cause condensation and fog the glass. This condensation is normal and will disappear in a few minutes as the glass heats up.
DO NOT BURN THE APPLIANCE WITHOUT THE GLASS FRONT IN PLACE.
During the first few fires, a white film may develop on the glass front as part of the curing process. The glass should be cleaned or the film will bake on and become very difficult to remove. Use a
ADJUSTING FLAME
HEIGHT
Your heater has an adjustable fl ame to tailor the look and heat output to your specifi c needs. It is adjusted by turning the fl ame adjustment dial on the gas control valve.
Turn clockwise to adjust the fl ame higher, coun- terclockwise for a lower fl ame.
LIGHTING
PROCEDURE
IMPORTANT
To ignite or reignite the pilot, the door to the firebox must be opened.
Only when the pilot holds, without pressure being applied to the control knob, should the door to the fi rebox be closed. The unit must never be operated with the glass or door open.
NOTE: For all propane units and units equipped with electric spark boxes, see "Copy of Lighting Plate Instructions" sec- tion for more details.
IMPORTANT: Gas on/off knob cannot be turned from "PILOT" to "OFF" unless it is partially depressed.
1)Turn stove OFF using the Burner "ON/OFF" switch remote or thermostat. Switches are
SHUTDOWN
PROCEDURE
1)Use the thermostat or remote control to turn off the main burner.
2)Turn the main gas control clockwise to the "OFF" position to turn off the pilot (push knob in slightly).
3)Turn off all electric power to appliance if service is to be performed.
FIRST FIRE
The FIRST FIRE in your stove is part of the paint curing process. To ensure that the paint is properly cured, it is recommended that you burn your fi replace for at least four (4) hours the fi rst time you use it with the fan on. When fi rst oper- ated, the unit will release an odour caused by the curing of the paint and the burning off of any oils remainingfrommanufacturing.Smokedetectors in the house may go off at this time. Open a few
AUTOMATIC
CONVECTION
FAN OPERATION
The fan operates automatically - turn the knob at the top right rear corner to adjust to the de- sired speed. The fan will turn on as the stove comes up to operating temperature. After the unit has been turned off and the unit cooled to below a useful heat output range the fan will shut off automatically.
Hampton® | 37 |
