INSTALLATION
CONVERSION KIT #434-969 FROM NG TO LP
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG Conversion Kit and one DC Sparker Kit.
LPG Conversion Kit Contains:
Qty. Part # | Description |
1
1
LPG"
1
1 | 5/32" Allen Key | |
1 | LPG Injector | |
|
| (Pilot Orifi ce) |
1 | Instruction Sheet | |
DC Sparker Kit Contains: | ||
Qty. Part # | Description | |
1
1
1
1 | Nut |
1
1
0.500 in.
1
2
1 | Spark Generator | |
|
| Battery Holder |
1 | Spark Generator | |
|
| Switch C/W Wire |
1
2
1
Ground 30 in.
Installation of the LPG
Conversion Kit:
1)Shut off the gas supply.
2)P33-4 Only:
a)Remove the louvers (and bay door if it is installed).
b)Open the fl ush door and remove the door.
c)Remove the logs, embers, and brick panels (if used).
d)Remove the 2 screws holding the Burner Assembly to the fi rebox base. Push the Burner Assembly to the left and lift out.
Remove the 2 screws, push BurnerAssembly to the left and lift out.2)H25-1 Only:
a)Lift off the Cast Top and remove the glass front (refer to Glass Replacement section in the
b)Remove burner by removing the 2 screws on each side and then lifting the burner tray out.
ScrewsNote: Use a magnetic type
screwdriver if possible.
Pilot assembly is now accessible forsteps 4) to 9).
3)Pull off the pilot cap to expose the pilot orifi ce.
4)Unscrew the pilot orifi ce with the Allen key and replace with the LPG pilot orifi ce in the kit and replace pilot cap.
5)Remove burner orifi ce with a 1/2" wrench and discard. Use another wrench to hold on to the elbow behind
the orifi ce.
Burner Orifi ce
6)Reinstall new burner orifi ce LPG stamped #54 and tighten.
Hampton® | 29 |
