INSTALLATION
DECORATIVE DOOR | WALL THERMOSTAT | ||
GRILL INSTALLATION | A wall thermostat may be installed if desired. | ||
|
| ||
1) Turn the Grill Latches on the Rear of the | Connect the wires as per the wiring diagrams. | ||
Door Grill as per the photo below. | Note that the wires are connected to the "TH" | ||
on the gas valve. Use table below to determine | |||
|
| ||
|
| the maximum wire length: | |
|
| Note: Preferable if the thermostat is installed | |
|
| on an interior wall. | |
Grill | Grill | Hampton® offers an optional programmable | |
Latch | |||
Latch | thermostat but any | ||
|
| ||
anticipator type thermostat that is CSA, ULC or UL approved may be used.
REMOTE CONTROL
Use the Hampton® Remote Control Kit approved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.
1)Choose a convenient location on the wall to install the receiver and the receptacle
Rear View of
Decorative Door Grill
2)Place the Door Grill into the Cast Front. Secure the Door Grill by turning the Grill Latches inward, between the glass and the Cast Front.
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
Thermostat Wire Table
Recommended Maximum Lead Length
Thermostat
Wire Size | Max. Length | |
14 GA. | 50 | Ft. |
16 GA. | 32 | Ft. |
18 GA. | 20 | Ft. |
20 GA. | 12 | Ft. |
22 GA. | 9 | Ft. |
|
|
|
box (protection from extreme heat is very important). Run wires from the fi replace to that location, use Thermostat Wire Table.
2)Connect the wires as per the wiring diagram below.
CAUTION
Do not connect the
millivolt remote control wires
to the 120V wires.
3)Install 3AAAalkaline batteries in transmitter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.
Turn the Grill Latches inward to secure the
Door Grill.
34 | Hampton® |
