5 INSTALLATION OF PAPER
Moisture, fingerprints or dust on the paper surface may cause a noise at printing or deterioration in print quality. Set the paper in the following procedure to prevent adhesion of fingerprint or dust on the paper
1surface.
Open the door.
• Switch the lever located on the left side to the “OPEN” position.
2 The door opens.
Load the paper roll.
•Place the paper roll in the printer.
printing side
INCORRECT CORRECT
Note: The printing surface is the outside. Place the paper with the thermo- sensitive side (printing side) up. When the paper roll is placed inversely, images can not be printed.
3Pull out the paper end.
• Pull out the first 15-
20cm (6 in. - 9 in.) of
the paper to remove any slack in the roll.
4Close the door.
5
Cut the paper end.
cutter
•Cut the paper end with the cutter just like tearing off the paper.
8