![](/images/new-backgrounds/1256986/25698625x1.webp)
I I I . I N S T A L L A T I O N | |
PHILLIPS HEAD SCREW 10 MM |
|
MOTOR HOUSING | |
| UPPER POST |
| |
| |
|
Figure 11. | Figure 12. Fully Assembled Lift (SilverBoom 300 Shown) |
ELECTRICAL WIRING INSTALLATION
1.Route the lift’s long power wire (starting at the lift) through the interior of the vehicle until you reach the automobile battery. See figure 13 and 13A. Conceal the wire behind or under the interior panels (there should be existing holes). Be certain that the wire is protected with a rubber grommet when passing it through the metal panels and into the engine compartment. Inside the engine compartment, secure the wire to the firewall and the inner fender with the supplied plastic wire ties. Use care not to cause abrasions to the power wire. It is important to secure the power wire at various points along its run.
2.Insert the red positive (+) lead on the power wire into the spliced end of the red positive (+) battery lead, then crimp the splice to secure the wire.
3.Connect the red positive (+) battery lead to the positive (+) battery terminal and the black negative
WARNING! The red positive (+) wire must be connected directly to the positive (+) battery terminal.
WARNING! The black negative
4.Connect the harness extending from the motor housing to the harness coming from the battery (black to black and red to red).
SilverBoom 300 | www.silverstarlifts.com | 13 |