Pride Mobility INFMANU3210 manual I . Installation, Power Rotating Base Shroud RE- Moval

I I I . I N S T A L L A T I O N

The SilverBoom can be installed in either side of your vehicle. The illustrations demonstrate installation on the right side.

POWER ROTATING BASE SHROUD RE- MOVAL

Installing a power rotating base requires that the base shroud be removed in order to access the rear mounting holes of the L-base. See figure 1.

1.Remove the 4 screws that secure the shroud to the base.

2.Carefully lift the shroud up and off of the base.

NOTE: SilverBoom lifts that have a power rotat- ing base should only be installed into a van or SUV.

DETERMINE L-BASE LOCATION

WARNING! The lift is heavy. Assistance may be necessary during installation. Use proper lifting techniques and avoid lifting beyond your physical capability.

1.Assemble the L-Base. See figure 2. For optimal use, insert the base extensions into the L-base at their farthest extension point and install the hardware (nuts and bolts). The base extensions can be ad- justed to accommodate obstructions.

NOTE: Always insert the bolt from the inside of the L-base. This allows the base extensions to be properly tightened without rattling.

2.Before permanently installing the lift, place the L- base inside your vehicle in the area in which you in- tend to install it. See figure 3 for L-base positioning for SUV’s and vehicles with hatchbacks, or figure 4 for trunk installation.

NOTE: Positioning the L-base close to the rear allows the boom-arm to stay as short as possible; this enables the boom-arm to swing freely without making contact with the motor vehicle.

SCREWS

SCREWS

Figure 1. Power Rotating Base Shroud Removal

BASE EXTENSIONS

L-BASE

BOLT 55 MM (2.5”)

NUT

Figure 2. L-Base Extensions

Figure 3. L-Base (Hatchback Installation)

8 www.silverstarlifts.com SilverBoom 300