I V . O P E R A T I O N
Remote Control Battery Replacement
As with all electronic devices powered by batteries, the battery of the remote control will eventually need to be replaced. When the lift responds intermittently or no longer responds to the commands from the remote control, replace the battery.
To replace the batteries of the remote control:
1.Loosen and remove the screws from the back of the remote control.
2.Remove the old battery. The battery slides in and out from the side. Do not lift the battery straight up.
3.Replace old battery with one of the same size (CR2430
4.Reassemble the remote control.
LIFTING THE MOBILITY PRODUCT
DOCKING DEVICE |
LIFTING HOOK |
Figure 15. Lifting Hook Placement
WARNING! Before operating the SilverBoom for the first time, be absolutely certain you have the proper docking device for your mobility product.
1.Prepare your mobility product for transport. Ensure that the power is off or key is removed and properly secure the batteries. You may also need to lower the tiller and/or remove the seat.
2.Position your mobility product on the ground behind the installed lift. Be sure that there is ample space between the mobility product and the vehicle bumper to ensure that the mobility product will not hit the bumper while being raised. If the mobility product is too far from the vehicle’s bumper, the mobility prod- uct will be dragged when attempting to lift it.
3.Position the
4.Operate the lift (via the hand/remote control in the downward direction until the lifting hook reaches the
Figure 16. Lifting Strap Warning Label
WARNING! Inspect the lifting strap before each use for twisting, fraying, and signs of wear.
∀Keep tension on the lifting strap with your free hand when lowering the lifting hook.
∀Lower the lifting hook only to the
WARNING! Do not extend the lifting strap past the warning label located on it. See figure 16.
5.Place the lifting hook onto the docking device
6.Operate the lift in the upward direction.
16 | www.silverstarlifts.com | SilverBoom 300 |
