12 
USE OF CLEANING PAPER
When the thermal head is dirty with dust and perspiration, etc., white spots or stripes may appear on the print. In this case, clean the thermal head in the following procedure BY USING THE SUPPLIED CLEANING PAPER.
1 | Turn on the power. | 4Close the door. |
| Press the "POWER" | Close the door |
| switch to turn on the | |
| without taking out | |
| power. | |
| the cleaning paper. | |
|
| |
2 | Open the door. |
|
| Switch the left side |
OPEN | lever to the "OPEN" |
| position. |
3Insert the cleaning paper.
56Press the "FEED" button.
FEED
Keep pressing the "FEED" button until you hear a beep.
Roll the cleaning paper and install into the set.
Cleaning paper
Take out the cleaning paper.
Open the door.
OPEN
Take out the
cleaning paper.
Red mark | Adjust the red mark |
| |
| on the cleaning |
| paper parallel to the |
| platen roller. |
Platen roller Cleaning paper | |
Do not pull out the cleaning paper while the door is closed.
7Repeat the steps
CAUTION
It is recommended that after printing 10 rolls of paper the unit be cleaned using the supplied cleaning paper.
If the symptom of the dirty head is not corrected even after cleaning, your set needs repairing, contact your dealer. Do not pull out the sheet and the cleaning paper while the door is closed.
This may cause extensive damage on the unit.
0Never use other cleaning papers. It may cause damage to the thermal head.
This cleaning paper should be used only for cleaning the thermal head. Do not use it for other purpose.
19
