Hampton Direct H25-NG1, H25-LP1 Important Message, Instructions, Before You Start, Save These

INSTALLATION

	IMPORTANT MESSAGE		This appliance installation must comply with the	DUE TO HIGH TEMPERATURES,
			manufacturer's installation instructions and local
		SAVE THESE	codes, if any. In the absence of local codes fol-	THE APPLIANCE SHOULD BE
		INSTRUCTIONS	low the current National Fuel Gas Code, ANSI	LOCATED OUT OF TRAFFICAND
			Z223.1 and the current National Electrical Code	AWAY FROM FURNITURE AND
The Direct Vent Freestanding Gas Stove must			ANSI/NFPA 70 in the U.S.A., and the current	DRAPERIES.
			CAN/CGA B149 Gas Installation Code and the
be installed in accordance with these instruc-			current Canadian Electrical Code CSA C22.1
				WARNING: FAILURE TO INSTALL
tions. Carefully read all the instructions in this			in Canada.
manual fi rst. Consult the building authority				THIS APPLIANCE CORRECTLY
having jurisdiction to determine the need for a			This Hampton® Mobile/Manufactured	WILL VOID YOUR WARRANTY
permit prior to starting the installation.			Home Listed appliance comes factory
				AND MAY CAUSE A SERIOUS
			equipped with a means to secure the
Note:		Failure to follow the instructions		HOUSE FIRE.
			unit.
		could cause a malfunction of the
		heater which could result in death,		CHILDRENANDADULTSSHOULD
			This Hampton® Mobile/Manufactured
		serious bodily injury, and/or prop-
			Home listed appliance comes equipped	BE ALERTED TO THE HAZARDS
		erty damage. Failure to follow these
		instructions may also void your fire	with a dedicated #8 ground lug to which	OF HIGH SURFACE TEMPERA-
		insurance and/or warranty.	an 18 gauge copper wire from the steel	TURES, ESPECIALLY THE FIRE-
Note: These instructions take precedence			chassis ground must be attached.	PLACE GLASS, AND SHOULD
				STAY AWAY TO AVOID BURNS
		over Simpson Dura-Vent instruc-	Thisappliancemayonlybeinstalledin
				OR CLOTHING IGNITION.
		tions.	an aftermarket permanently located,
			manufactured (USA only) or mobile
	SPECIFICATIONS
				YOUNG CHILDREN SHOULD
			home, where not prohibited by local
Fuels:		H25-NG1 is approved for use with	codes.	BE CAREFULLY SUPERVISED
				WHEN THEY ARE IN THE SAME
		natural gas.	This appliance is only for use with
				ROOM AS THE APPLIANCE.
		H25-LP1 is approved for use with liq-	the type of gas indicated on the rating
		uefi ed petroleum gases (propane).	plate. This appliance is not convert-	CLOTHING OR OTHER FLAM-
			ible for use with other gases, unless
				MABLE MATERIALSHOULD NOT
Electrical: 120V A.C. system.			a certified kit is used.
				BE PLACED ON OR NEAR THE
Optional Circulation Fan:				APPLIANCE.
		Variable speed, 125/75.	BEFORE YOU START	1) Provide adequate clearances for servicing,
Log Sets: Ceramic fi bre, 4 per set.					properoperationandaroundtheairopenings
					into the combustion chamber.
			Safe installation and operation of this appli-
Vent System: Coaxial (6-5/8" outer / 4" inner
			ance requires common sense, however, we	2) The appliance must be installed on a fl at,
liner) rigid fl ue and termination cap.			are required by the Canadian Safety Standards		solid, continuous surface (e.g. wood, metal,
			and ANSI Standards to make you aware of the		concrete). This may be the fl oor, or it can be
			following:		raised up on a platform to enhance its visual
	INFORMATION FOR
					impact. The appliance may be installed on
					carpeting, tile, wood fl ooring or other com-
		MOBILE /	INSTALLATION AND REPAIRS
					bustible material, because the appliance's
	MANUFACTURED		SHOULD BE DONE BY A QUALI-		base extends the full width and depth of the
			FIED SERVICE PERSON. THISAP-		appliance. The Direct Vent Freestanding
		HOMES	PLIANCESHOULDBEINSTALLED,		Gas Stove can be installed in a wide variety
					of ways and will fi t nearly any room layout.
	AFTER FIRST SALE		REPAIRED, INSPECTED BEFORE
					It may be installed in a recessed position,
			USE AND AT LEAST ANNUALLY
					framed out into the room, or across a cor-
This Hampton® product has been tested and			BY A QUALIFIED SERVICE PER-		ner.
			SON. MORE FREQUENT CLEAN-
listed by ITS Testing Services as a Direct Vent				3)	The Direct Vent Freestanding Gas Stove is
			ING MAY BE REQUIRED DUE TO
Wall Furnace to the following standards:
					approvedforalcoveinstallations,whichmeet
CGA-2.17-M91, and ANS Z21.88b-2003/CSA			EXCESSIVE LINT FROM CARPET-
					the clearances listed on in the "Clearance
2.33b-2003.			ING, ETC. IT IS IMPERATIVE THAT		to Combustibles" section. This unit is ap-
This Direct Vent System Appliance must be			THE CONTROL COMPARTMENT,		proved for manufactured home installations,
			BURNERS AND CIRCULATING		see the "Manufactured Mobile Home Addi-
installed in accordance with the manufacturer's
					tional Requirements" section and "Venting
installation instructions and the Manufactured			AIR PASSAGEWAYS OF THE AP-
					Arrangments" section for the required vent
Home Construction and Safety Standard, Title			PLIANCE BE KEPT CLEAN.		arrangements. If installed into a manufac-
24 CFR, Part 3280, or the current Standard of					tured home the unit must be bolted down
Fire Safety Criteria for Manufactured Home In-
					to the fl oor.
stallations, Sites, and CommunitiesANSI/NFPA
501A, and with CAN/CSA Z240-MH Mobile				4)	This appliance is Listed for bedroom instal-
Home Standard in Canada.
					lations when used with a Listed Millivolt
6			Hampton® H25-1 Direct Vent Freestanding Gas Stove