Assembly
9 | Press Here |
|
•Insert two #10 x 3/4" screws through the slots in the headlight and into the pegs in the handlebar.
•Press firmly on the front of the headlight and tighten each screw with a Phillips screwdriver. Make sure there is no gap between the headlight and the handlebar.
10 | Microphone |
|
Cord |
| |
|
| |
Microphone |
| |
|
| |
| Knobs |
|
| Slot | Handlebar |
| Console | |
|
| |
| Key Assembly |
|
11 Handlebar
Handgrip | Handgrip |
| |
|
|
• Fit a handgrip onto each end of the handlebar.
Helpful Hint: If the handgrips are difficult to slide onto the handlebar, moisten the handgrips with warm water before fitting them onto the handlebar.
12 |
|
|
|
|
| Handlebar |
| ||
|
| Wire Harness |
| |
|
|
|
| Connector |
|
|
|
| |
| Button End |
| ||
|
|
| End | |
|
|
|
|
|
Rectangular
Opening
Handlebar
•Insert the connector end of the handlebar wire harness into the rectangular opening in the handlebar.
•Feed the handlebar wire harness through the handlebar.
•Push firmly on the button end of the handlebar wire har- ness to snap it into the rectangular opening.
•Snap the knobs and key assembly into the handlebar console.
•Bend the end of the microphone cord so that it forms a "T".
•Insert the end of the microphone cord through the small hole in the handlebar console.
•Fit the tab on the back of the microphone into the slot in
the handlebar console. | 11 |
|
