| Assembly |
|
|
21 | 23 |
|
|
|
|
| |
| Grooves | Footrest | Footrest |
|
| Support | Support |
|
| Bar |
|
| Footrest |
|
|
Please Note: If you have not removed the protective foam | • Insert the footrest support bar through the footrest | ||
pocket from the battery compartment, please remove it | |||
and set it aside for later use. Remove any excess tape | support at the bottom of the vehicle body. Make sure the | ||
from the vehicle and protective foam pocket and discard of | grooves on the footrest face up. |
| |
the tape properly. | • Align the holes in the other footrest with the holes on the | ||
• Stand the vehicle body on its rear wheels. | other side of the footrest support and repeat assembly | ||
• Align the holes in the | step 22 on the other side of the footrest support. | ||
|
| ||
underside of the vehicle body, directly under the battery | 24 |
| |
compartment. |
| ||
• Insert three #8 x 1/2" screws through the floor of the bat- | Footrest | ||
tery compartment and into the |
| ||
• Tighten the screws with a Phillips screwdriver. Do not |
|
| |
|
| ||
• Position the vehicle body upright. |
|
| |
22 Holes |
|
| |
Footrest |
|
| |
Support Bar |
|
| |
Footrest |
|
| |
Hole | • Turn the vehicle body on its side. |
| |
• Using a Phillips screwdriver to steady the screw and | |||
| |||
| pliers to grip the lock nut, continue to tighten the bolt and | ||
| lock nut on each footrest. |
| |
| • Turn the vehicle body upright. |
| |
| One time assembly is now complete. Do not assemble | ||
• Align the holes in a footrest with the holes in one end of | the seat until after you have charged and installed | ||
the battery in the vehicle. Please refer to the Battery | |||
the footrest support bar. | |||
Installation section beginning on page 16 for | |||
• Insert a #10 x 11/4" bolt through the footrest and footrest | |||
instructions. |
| ||
support bar. |
| ||
|
| ||
• Fit a lock nut onto the end of the bolt and hand- | 14 |
tighten it. |
