![](/images/new-backgrounds/1290792/29079223x1.webp)
FASSEMBLY
|
| A | Spacers |
|
| Grille |
|
|
|
| 14 |
| B | #8 x 3" Screws |
|
|
|
| |
• | Fit two spacers between the grille and the back of the brush guard, | |||
| as shown | A . |
|
|
•Insert two #8 x 3" screws through the inside of the headlight, the spacers and into the holes in the grille B . Tighten the screws.
Short Seat |
|
Belt Strap | |
| Fastener End |
| |
Slot |
|
Seat
Slot
16
•Turn the seat upside down.
•Insert the fastener end of a short seat belt strap through the slot near the outer edge of the seat. Make sure the side of the seat belt with the fastener faces the outer edge of the seat.
•Pull the short seat belt strap completely through the slot until the last
•Repeat this procedure to assemble the other short seat belt strap.
Headlights
15 | Brush Guard | Light |
| Covers |
•Fit the light covers to the headlights.
•Insert #10 x 1/2" screws into the light covers. Tighten the screws.
Long Seat Belt Strap
T-Loop
Fastener End
17
•Insert each fastener end of the long seat belt strap through a slot in the center of the seat. Make sure the fasteners face the outer edge of the seat.
•Pull each side of the long seat belt strap evenly through the slots. Make sure to pull each
•Turn the seat upright.
12 |