F |
| ASSEMBLY |
|
| Sport Bar Support |
| Taillight |
|
| Housing | |
|
|
| |
| PUSH |
|
|
| HERE |
|
|
Side |
|
|
|
Fender |
|
|
|
|
|
| Taillight |
|
|
| Lens |
| PULL |
|
|
| HERE | #8 x 1" Screws | |
|
| ||
22 |
| 24 | BACK VIEW |
SIDE VIEW |
|
| |
• | Turn the vehicle upright. |
•Fit the sport bar assembly into the holes in the top side of the vehicle.
•Push down firmly on a sport bar support while pulling up on the side fender to fit the sport bar into the vehicle.
•Repeat this procedure on the other side of the vehicle.
| Rear of |
| Vehicle |
23 | BOTTOM VIEW |
•Turn the vehicle on its side.
•Insert two #10 x 3/4" screws into the holes (behind the rear wheels) in the underside of each rear wheel well, through the vehicle body and into the ends of the sport bar. Tighten the screws.
•Next, insert two #10 x 3/4" screws into the holes (in front of the rear wheels) in the underside of each wheel well, through the vehicle and into the ends of the sport bar. Tighten the screws.
•Using safety scissors, remove the taillight lenses and the taillight housings from the plastic connectors. Dispose of the plastic connectors.
•Face the rear of the vehicle.
•Fit a taillight lens inside a taillight housing.
•Position the taillight housing with lens against the vehicle with the screw holes aligned, as shown.
• | Insert two #8 x 1" screws through the taillight lens, housing and into |
| the vehicle as shown. Tighten the screws. |
• | Repeat this procedure to attach the other taillight assembly. |
| Cap |
| Tether |
| 25 |
•Position the cap so that the tether is down.
•Snap the cap into the hole under the right taillight.
14 |
