25
Problems and Solutions

Problem Probable Cause Solution

Motor is not running; no swinging Power is not on Turn the power dial to one of six settings.
Batteries incorrectly installed Remove the batteries and replace in correct
orientation, as indicated inside the battery
compartment.
Dead batteries Replace all four batteries with four, fresh “D”
alkaline batteries or switch to AC power.
Motor is running but swinging stops after a
few minutes Need to start swinging motion To start swinging motion, give the seat a
light push.
Swing motion setting is inappropriate for
child’s weight Adjust the power dial to a higher speed set-
ting and give the seat a light push.
Weak batteries Replace all four batteries with four, fresh “D”
alkaline batteries or switch to AC power.
No difference noticed in swinging motion
after power dial is adjusted Swing did not have sufficient time to adjust
to different setting Allow the swing time to adjust to
new setting.
Weak batteries Replace all four batteries with four, fresh “D”
alkaline batteries or switch to AC power.
Swinging motion too high even at the lowest
setting Normal operation To slow swinging motion, place one end of
a blanket underneath your child and let the
other end drape down while swinging.
Waterglobe (lights)/mobile, music/sounds
do not work and swing is off Power dial is not on correct setting Position the power dial to the position.
Dead batteries Replace all four batteries with four, fresh “D”
alkaline batteries.
Waterglobe (lights)/mobile, music/sounds
turn off automatically after seven minutes Press the reset button to restart water-
globe (lights)/mobile, music/sounds for
another seven minutes.
Music/sounds do not work (and power dial
is set to )Music/sounds switch is in OFF position Slide music/sounds switch to desired setting
.
Music/sounds turn off automatically after
seven minutes Press the reset button to restart music/
sounds for another seven minutes.
Waterglobe (lights) does not work (and
power dial is set to )Mobile/waterglobe switch is in OFF posi-
tion or mobile only position Slide mobile/waterglobe (lights) switch to
desired setting .
Waterglobe (lights)/mobile turn off auto-
matically after seven minutes Press the reset button to restart water-
globe (lights)/mobile for another seven
minutes.
Mobile does not work (and power dial is set
to ) Mobile/waterglobe (lights) switch is in OFF
position or waterglobe only position Slide mobile/waterglobe (lights) switch to
desired setting .
Mobile/waterglobe (lights) turn off automati-
cally after seven minutes Press the reset button to restart
mobile/waterglobe (lights) for another
seven minutes.