Acoustic Imaging Blender Aura™ | Inner Workings - continued |
Effect on/off Switch
The Effect on/off lets you bypass the blended sound image/pickup mixes in both the Play and Edit modes, so that only the basic pickup signal from your instrument appears at the Aura’s outputs. Use the Effect on/off switch to help set baseline levels for your mixes (see Level above) and to compare your raw pickup sound to the processed sound.
Tuner
This digital chromatic tuner has several programmable features to fit your performance needs. When the tuner is engaged, it is factory set to mute the Aura’s outputs. The mute can also be disabled (see below).
Tuner Setup
1 Move Edit/Play switch to Play
2Press the two bracketed Tuner On (UP and Down) footswitches simultaneously to activate the tuner.
3Play an open string and the tuner will show the closest note name in the display.
4Watch the LEDs over each foot switch to dial in the note.
5If the left LED lights, the note is flat.
6If the right LED lights, the note is sharp.
7When the center LED lights, the note is in tune.
8To shut off the tuner, press either the Tuner Off (Feedback Cancel) footswitch or both the bracketed Tuner ON (UP and Down) footswitches simultaneously.
Mute Defeat
If you wish to override the mute function of the tuner, tap the Down footswitch when the tuner is engaged. A dot will light up in the upper left corner of the display and the pickup signal will appear at the Aura’s outputs. This will now be the normal operating state of the tuner, unless you press the Down footswitch again and
If you wish to
TROUBLESHOOTING TIP: If the Tuner is not registering when you play, it may not be seeing enough signal from your instrument. Raise the Input level until the middle yellow LED flashes frequently when you play aggressively and the tuner will start tracking properly.
23