6 Messages

6.1 Table

Ware

Messages

Message “The [report][table] was successfully exportedto filename.”
Message “The raw data that was enteredmay contain errors or may be inappro-
priate for the selected type of coefficients. Carefully check the raw data for er-
rors before attempting to calculate coefficients again.”
Remarks Tabl eWar e wasnot able to calculate coefficients based on the raw
data that was entered. Check the raw data for mistakes and attempt to calculate
the coefficients again.
Message “Atleast one ITS-90 range must be selected to calculate ITS-90
coefficients.”
Remarks When calculating ITS-90 coefficients,a low range, high range or
both must be selected. Selecting None for both the lowand high range is not
permitted.
Message “Every coefficient must havea value. [Other information.] Finish fill-
ing in the coefficient valuesthen select Continue.”
Remarks When entering coefficients to generate a table, all listed coefficients
must have a valueentered into the box. Enter values for all coefficients.
Message “CoefficientsR0, ALPHA and DELTA must have values.BETA can
be left blank. Finish filling in the coefficient values then select Continue.”
Remarks When entering Callendar-VanDusen coefficients to generate a table,
the R0, ALPHA and DELTAcoefficients must have a valueentered into the
boxes. Enter values for these coefficients.
Message “Unable to retrievestandard thermocouple coefficients. Cannot
continue.”
Remarks Togenerate a thermocouple table, the standard coefficients must be
read in from the CALCCOEF.DLLfile. Make sure the CALCCOEF.DLL file is
located in the \WINDOWS\SYSTEM or \WINNT\SYSTEM directory. Alterna-
tively,this file can be placed in the directory where the application is installed.
Message “Warning:The selected temperature range exceeds the recommended
range for the coefficients. Calculations for any temperatures belowminimum
temperaturean d above maximum temperaturewill be extrapolated. Select OK
to continue or select Cancel to abort.”
Remarks The selected minimum and maximum temperatures for generating a
table exceed the lowest and highest set-points used to calculate the coefficients
or exceed the recommended temperature range for the coefficients being used.
In order to generate a table over the range specified, TableWare must use ex-
trapolation. For recommended temperature ranges for generating tables, see
57
6 Messages
TableWare Messages