OWNER’S MANUAL
SAFETY
INFORMATION
Continued
13.Do not use this heater to cook food or burn paper or other objects.
14.Do not use heater if any part has been exposed to or under water. Immediately call a qualified service technician to in- spect the room heater and to replace any part of the control system and any gas control which has been under water.
15.Do not operate heater if any log is bro- ken. Do not operate heater if a log is chipped
16.Turn heater off and let cool before ser- vicing, installing, or repairing. Make sure the remote selector switch is in the OFF position. Only a qualified service person should install, service, or repair heater.
17.Make sure the remote selector switch is in the OFF position when you are away from home for long periods of time.
18.Operating heater above elevations of 4,500 feet could cause pilot outage.
19.Provide adequate clearances around air openings.
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note: Where listed vented decorative logs are required, thermostat operation is not permitted.
UNPACKING
CAUTION: Do not remove the data plates from the grate assem- bly. The data plates contain impor- tant product information.
1.Remove logs and heater base assem- bly from carton. Note: Do not pick up heater base assembly by the burner. This could damage heater. Always handle base assembly by grate.
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by realistic, dancing yellow flames. This heater is designed for
SAFETY PILOT
This heater has a pilot with an Oxygen Deple- tion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent- free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
PRODUCT | 2. | Remove all protective packaging ap- |
| plied to logs and heater for shipment. | |
IDENTIFICATION |
| |
3. | Check all items for any shipping dam- |
age. If damaged, promptly inform dealer where you bought heater.
REMOTE CONTROL ACCESSORIES
There are four optional remote controls that can be purchased separately for this log heater:
Piezo Ignitor
Selector
Switch
AUTO
OFF
I
H
| LO |
IH |
|
LO |
|
O | |
NO | F |
F | |
T O | P |
Flame Adjustment Knob
One Piece Log Set
Base Assembly
•wall switch
•wall thermostat
•
•
See Accessories, page 21.
The wall thermostat or
Figure 1 - Product Identification
Control Knob
105194 | 3 |