WHAT TO DO IN CASE OF A PROBLEM
The symbol [ E 4 ] displays :
∙The hob must be configured according to the following procedure.
I)Warning : before starting all pots must be removed from the cooktop.
II)Disconnect the cooktop from the main supply : remove fuse or disconnect circuit breaker.
III)Connect the cooktop to the main supply : replace the fuse or connect the circuit breaker.
IV) Procedure : You must provide yourself with a ferromagnetic bottom container 16 cm minimum diametre.
* start within 2 minutes after the connection to the main supply
*do not use the [ O/I ] key.
V)How to cancel the existing configuration :
1)Push on the locking key and keep your finger on the key
2)With a finger from the other hand activate successively and quickly a - b - c (7322240) or d - e - f (7321240) keys. Start from left to right. A double "beep" sound will inform you of a bad manipulation and you will have to restart from point 1.
a | b | c | d | e | f |
3)The left display shows alternatively a [ C ] and a [ 0 ]
4)Press the key lock until both displays indicate either [ C ] or [ - ].
5)Take your fingers away from the keys and press again the [ - ] key during a few seconds until some [ E ] appear.
6)You will hear a "beep" sound and the [ E ] will blink.
7)The [ E ] are automatically transformed into [ C ] → The configuration has been canceled.
VI) How to configure the hob ?
1)Use a suitable induction pot with a minimum diametre size of 16cm.
2)Select the heating zone by pushing the corresponding [ + ] key.
3)Put the pot on the corresponding heating zone.
4)Wait until [ C ] converts to [ - ]. The zone is configured
5)Use the same procedure for each other heating zone which displays [ C ]
6)The configuration is made if all zones are detected and if nothing is displayed Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
∙If [ E 4 ] display persists call the
The hob or the cooking zone doesn’t start-up
∙The hob is badly connected on the electrical network.
∙The protection fuse
∙The locking function is activated
∙The sensitive keys are covered of grease or water.
∙An object is put on a key.
23