Model
Overdubbing the electric bass to Track 2 while listening to Track 1 (drum machine)
Before you start overdubbing, practice your electric bass performance while monitoring the drum machine recording in Track 1 through the headphones.
5
4 5
3
Electric bass
Effects unit
7
1 6
1
2 | 8 | 5 | 10 | 8 | 9 |
|
|
|
1Insert the tape on which the drum machine has already been recorded, and rewind the
tape to the recording start position "000."
2The output of the effects unit to which the electric bass is connected is plugged into
the [INPUT] jack.
3Rotate the
Adjust the recording level of the electric bass.
4Play the electric bass to check to see how the level meter is responding. (Use the output volume on the bass so that the level is not too high.) Use the [LINE OUT/PHONES] knob to adjust the headphone volume to an appropriate level.
7Using the [REC TRACK] selector, select track 2 for recording.
Press the [PAUSE] button, the press the [REC]
8button.
The X-12 will enter record pause mode.
Press the [PAUSE] button again to cancel record
9pause mode and start recording.
Overdub the electric bass on Track 2, accompanying the drum machine on Track 1, while watching the recording level.
<NOTE>
Do not move the [REC TRACK] selector during recording. If this is moved accidentally during recording, the recording track will be switched.
After you set the recording level, playback
5 the tape from the "000" point and rehearse your bass accompanying the drum machine recording on Track 1.
Use playback level fader 1 and the playback [PAN] knob 1 to adjust the monitoring level and balance of Track 1.
After you finish recording, press the [STOP]
10 button or the [PAUSE] button to stop the tape.
If you have pressed the [PAUSE] button, press the [STOP] button to release the [REC] button and [PLAY] button, then press the [PAUSE] button again.
6After you finish rehearsing, rewind the tape to the "000" point.
13
