Foundry Networks OSI manual Installing the Switch, Selecting a Site

CHAPTER 4 INSTALLING THE SWITCH

Selecting a Site

EdgeIron 4802CF units can be mounted in a standard 19-inch equipment rack or on a flat surface. Be sure to follow the guidelines below when choosing a location.

◆The site should:

•be at the center of all the devices you want to link and near a power outlet.

•be able to maintain its temperature within 0 to 50 °C (32 to

122 °F) and its humidity within 5% to 95%, non-condensing

•provide adequate space (approximately two inches) on all sides for proper air flow

•be accessible for installing, cabling and maintaining the devices

•allow the status LEDs to be clearly visible

◆Make sure twisted-pair cable is always routed away from power lines, fluorescent lighting fixtures and other sources of electrical interference, such as radios and transmitters.

◆Make sure that a separate grounded power outlet that provides 100 to 240 VAC, 50 to 60 Hz, is within 2.44 m (8 feet) of each device and is powered from an independent circuit breaker. As with any equipment, using a filter or surge suppressor is recommended.

February 2003 © 2003 Foundry Networks, Inc. 4-1