Freescale Semiconductor Embedded Bootloader Reference Manual, Rev. 0.0 4-1
Chapter 4 Embedded Bootloader Programming This chapter describes how to program the Embedded Bootloader with a P&E Multilink for HCS08 BDM
debugger. The Embedded Bootloader is normally downloaded to the PCB where production data is also
written. Users must employ different procedures depending on what needs to be programmed. Users can
program the Embedded Bootloader to an empty (erased) PCB or they can upgrade to a newer version of
the Embedded Bootloader. Follow the procedures in Section 4.1, Programming To An Empty (Erased)
Board if the PCB is empty (erased).
Users must make a copy of the production data section in the NVM (see Section 5.3.5, NV_Data.c and
NV_Data.h) if they need to upgrade the Embedded Bootloader. This can be done either manually or
automatically by a custom made script with the command line version of the CPROG tool. The command
line version is not described further. Follow the procedures as shown in Section 4.2 on how to make a
copy of the production data.
4.1 Programming To An Empty (Erased) Board
This section describes how to program the Embedded Bootloader to an empty (erased) board.
1. Execute the HIWAVE.EXE file from your chosen installation directory. For example,
[installation directory]\Metrowerks\CodeWarrior_CW08_V3.0\Prog\
2. From the main window, setup the target by selecting the “Component” menu, then click on “Set
Target”. The “Set Target” window appears as shown in Figure 12.
Figure 12 Set Target Window
3. In the “Processor” drop down menu, select HCS08. From the “Target Interface” drop down menu,
select P&E Target Interface, the click on the “OK” button.