Freescale Semiconductor 802.15.4 manual Status Window

The Embedded Bootloader is now programmed to the PCB as shown in Figure 22.

Figure 22 Status Window

12.Write NVM production data back by selecting the “PEDebug” menu. Then select “Programming Options” and “Start Expert Mode Programmer”. Select “SS Specify S-record” and locate the PD_NVM.s19 file built in Step 10. Select the “PM Program Module” option and production data is written to flash.

13.Remove power and disconnect the BDM cable from PCB. Next, power up the PCB.

The PCB is now ready to upload an application. See Chapter 2 for more information about how to upload an application.

NOTE

The applications must have the production section in the NVM cleared. That is, the application image must contain 0xFF's in the production data section of the NVM.

Freescale Semiconductor Embedded Bootloader Reference Manual, Rev. 0.0 4-9